cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
214
Views
0
Helpful
1
Replies

220 Switch Error at startup and restarts every few hours

Grant51
Level 1
Level 1

Hi All - I purchased a CBS220-24t-4G switch a couple weeks back and have been unsuccessful at resolving these two issues. When starting up the switch after the system states Starting Kernel... I receive the following error: "unknown rt error f030". Has anyone experienced this? I updated the firmware and still have this error as well as the switch reboots itself every couple of hours. 

Grant51_0-1713356197180.png

 

1 Reply 1

marce1000
VIP
VIP

 

 - Smells like a (starting) hardware problem;  if the firmware is up to date , you could resort to a factory reset (attempt) save configuration first though and restore config afterwards , check if the problem remains. Also make a full power cycle included , 

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card