2800 IOS Support for HWIC-4ESW

[ashish.sehgal1]

System image file is "flash:c2800nm-advsecurityk9-mz.124-24.T5.bin"

Cisco 2811 (revision 53.51) with 247808K/14336K bytes of memory.
Processor board ID FHK0923F0NV
2 FastEthernet interfaces
2 Serial(sync/async) interfaces
1 Channelized (E1 or T1)/PRI port
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

I want to insert HWIC-4ESW card, wanna know if the current IOS Version 12.4(24)T5; will support this card ?

[Leo Laohoo]

Minimum Cisco IOS Software Release 12.3(8)T for 1841, 2800 Series and 3800 Series routers with IP Base Feature Set.

[ashish.sehgal1]

Thanks Leo, can you support with some cisco link confirming the same.

[Leo Laohoo · Accepted solution]

Yes, I can.  Go HERE and scroll down to Table 5, under the column of "Software Support". 

[ashish.sehgal1]

bro Leo,

I read:

● Minimum Cisco IOS Software Release 12.3(8)T for 1841. 280 Series and 3800 Series routers:
IP Base image.

sholdn't it be 2800 series ? looks this is typo from cisco. Please advise.

[Leo Laohoo]

It's a type-o.