Hi,
This is my first time when I am usig Cisco Support Community to ask for help, so I apologise if I've done something wrong,
My cisco 2811 router - I was trying several types of resistors, to reduce the level of noise on the fans, so I could practice at night without waking up the baby. It worked fine, the same type of resistors are working ok on my other Cisco gear. After fitting the resistors, I have connect a console cable, just to make sure everything is OK, and I have notice that I cannot establish a console connection any more. nothing come's back on the screen, no signs, nothing at all.
I have tried changing the settings on the serial conection, (baud rate, stop bit) ... no results.
I don't know how to try any other types of connections, telnet etc... as I remember, I have no IP address configured on the switch for management, to try telnet using a FastEthernet port.
I have tried two console cables, all working on my other devices.
the last time when I was testing the resistors, the switch was powered ON, do you think that I have burned the console port?
the switch still powers ON.
Help please,
Constantin
Regards,
Constantin