Hello Everyone:
I have spent hours putting together a "stub network," using SDM, for a single server behind a 2811 router with a HWIC-4ESW switch connected to the server's management port and its public ethernet port.
Each of the server's 2 ports is connected to one of the switch ports Vlan interface (its second ethernet port is not used).
Looking at server's public interface only for this running config detail.
FE0/0 will be connected to the ISP Ethernet cloud, currently setup with a laptop (A.B.78.1):
!
interface FastEthernet0/0
description $ETH-WAN$
ip address A.B.78.63 255.255.255.0
ip mask-reply
ip nat outside
ip virtual-reassembly
no ip route-cache
duplex full
speed auto
no mop enabled
!
interface FastEthernet0/0/0
description Public Interface
switchport access vlan 30
!
interface Vlan30
description Public Internet
ip address aa.bb.87.49 255.255.255.240
!
ip route 0.0.0.0 0.0.0.0 A.B.78.1 permanent
ip route aa.bb.87.0 255.255.255.240 aa.bb.87.50 permanent
!
The server's ethernet connection to vlan30 has an ipconfig: ip: aa.bb.87.50, mask: 255.255.255.240 & default gateway: aa.bb.87.49.
[1.] The router's Tools/Ping form will ping from FE0/0 to the server's ethernet aa.bb.87.50 -- no worries.
[2.] Similarly, the router's Ping Tool will ping from vlan30 to the laptop. (aa.bb.87.49 to A.B.78.1 = 100% 5/5).
Problems:
[1.] Using the command prompt ping tool from the server:
No ping from server aa.bb.87.50 to A.B.78.1. I can ping to A.B.78.63 (FE0/0).
[2.] Using command prompt ping tool from the laptop:
No ping from laptop A.B.78.1 to aa.bb.87.50. I can ping to aa.bb.87.49 (vlan30).
From looking at this, I think the problem is that the default routing to A.B.78.1 does not work for the vlan30 int traffic and that I need some sort of outbound vlan routing.
How do I do this? encapsulate? helper-address? There is a missing element here, and as frustration has taken over I cannot see it.
Can anyone point out the missing element?
Thanks in advance.
