Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
836
Views
0
Helpful
2
Replies

2960S config

Sean McCoy
Level 1
Level 1

‎07-22-2011 06:26 AM - edited ‎03-07-2019 01:21 AM

Trying to configure a 2960s stack. I stacked the switches and everything looks fine when I look at it via console connection. I have the VLAN 1 IP address configured for the stack. I put an address on the laptop in the same subnet. I cannot connect via the IP address assigned to VLAN 1. Did I miss something?

Labels:
0 Helpful
2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

‎07-22-2011 06:32 AM

Sean,

did you create an SVI for vlan 1?

interface vlan 1

ip address 10.10.10.1/24

no sh

is the vlan in up and up mode?

0 Helpful

manju.cisco
Level 3
Level 3

‎07-22-2011 07:21 AM

Hi,

I guess the port on the switch connectingn to the PC has been configured as trunk port.

Can you pls configured it as access port? It should ping then

Make sure you have not configured the port to different access vlan by mistake

If this still doesnt ping, pls post us your configuration and interface status.

Manju

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card