2960X doesn't Support RSPAN?

[kelvinffhan]

Hi Experts,

Is WS-C2960X-24TS-LL with c2960x-universalk9-mz.150-2.EX5 supported RSPAN? I have tried it out Today but unfortunately the command isn't accepted.

I have checked the release note it actually showing RSPAN are supported.

My next action plan will be upgrade the IOS version to the latest firmware and try. It is good if anyone can share out his/her thoughts.

My scenario would be like below :

6509 (Source) > 2960X > 3850X (Destination)

Regards,

[Reza Sharifi]

Hi,

It appears to be supported in 15.0(2) and later versions.

Have a look at this link for config examples:

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/network_management/configuration_guide/b_nm_15ex_2960-x_cg/b_nm_15ex_2960-x_cg_chapter_0111.html

HTH

[kelvinffhan]

Thanks for the reply. I will try my action plan again by Today and see.

[Madhukrishnan Gopinathan Nair]

Hi kelvin,

I looked at the config guide and it is supported. 

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/network_management/configuration_guide/b_nm_15ex_2960-x_cg/b_nm_15ex_2960-x_cg_chapter_0111.html#ID62

Have you defined a rspan vlan? Please share the error you are getting? And also share the confguraiton you are applying?

Thanks,

Madhu.

[Madhukrishnan Gopinathan Nair]

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/network_management/configuration_guide/b_nm_15ex_2960-x_cg/b_nm_15ex_2960-x_cg_chapter_0111.html

HTH

[kelvinffhan]

I am trying to apply the RSPAN vlan, it doesn't allow me to enter the command. It's showing invalid command
 

[Charles Hill]

Hello kelvinffhan,

try remote-span

instead of C2960X-SW02(config-vlan)#remote-vlan

Hope this helps...

[kelvinffhan]

Is this a hidden command? it doesn't showing in the configuration command.

[Madhukrishnan Gopinathan Nair]

Has it worked when you applied. ?

It shouldn't be a hidden command.

[kelvinffhan]

This is a new switch. While I tried to configure it prompted me this error.

[Madhukrishnan Gopinathan Nair]

Does it mean  you can't configure remote-span also?

Earlier you were trying remote-vlan which is incorrect

Thanks,

Madhu

[kelvinffhan]

Yes, both remote-vlan and remote-span are invalid. I am trying to hard code even it is not showing in the command configuration while I press "?".

[kelvinffhan]

Any idea?

[Madhukrishnan Gopinathan Nair]

I will check and let you know

[kelvinffhan]

Thanks Experts..