2960X stack

[alexmarin28]

Hi, is it possible to disable the stacking mode on a catalyst 2960x?

There is no stacking module but the stacking state is always ready:

Switch#  Role   Mac Address     Priority Version  State
----------------------------------------------------------
*1       Master 3462.8854.9400     1      4       Ready  

WS-C2960X-48LPS-L and WS-C2960X-24PS-L

15.0(2)EX5 C2960X-UNIVERSALK9-M

tks!

[Reza Sharifi]

Hi,

As long as you don't have any stacking cable connecting multiple switches together the switch is stand alone. There is no command to disable that.

HTH

[alexmarin28]

My probleme is when its time to monitor these switch. With Prime Infrasructure and Solarwinds, when the 2960X are set up in a stacking mode, the device type shows up as :

Prime = Cisco Catalyst 2960S

SolarWinds = C29XXStack

instead of: WS-C2960X-48LPS-L and WS-C2960X-24PS-L

[Reza Sharifi]

This is not a switch issue.  This is most likely an issue with Prime.

SolarWinds (NMP) version 11.0.1displays the 2960x correctly.

HTH

[Ashok Kumar]

Hi,

It's problem with Device Packs in Prime Infrastructure, you might need to update them.

Which version of prime you're using?

-Ashok 

***********************************************************************************************************

Please rate the post or mark as correct answer as it will help others to find it, who all need the help on similar information

************************************************************************************************************ 

[alexmarin28]

I use Prime 2.1 (2.1.0.0.87) and Solarwinds 11.0.1