you can use the license boot level command to enable the temporary license and accept the end-user license agreement (EULA) in configuration mode.
Additional info
Temporary License: - A temporary software license is limited to a usage period (around 60 days). After the usage period expires, the switch continues to use the temporary software license until it is restarted. Before it restarts, warning messages state the switch is running the feature set without a valid license. After the switch restarts, the switch uses a valid software license based on the hierarchy (ipservices>ipbase>lanbase). If the switch does not have a valid license, it uses the IP base software license.
Switch#show license Index 1 Feature: ipservices
Period left: 8 weeks 4 days <<<<<<< Limited usage period
License Type: Evaluation
License State: Active, Not in Use, EULA not accepted
License Priority: None
License Count: Non-Counted Index 2 Feature: ipbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Priority: Medium
License Count: Non-Counted Here is the link that you could use to request for a temporary license: https://tools.cisco.com/SWIFT/Licensing/PrivateRegistrationServlet?DemoKeys=Y Note: On this link you should give the correct UDI of the switch (use "show license udi")
