Even when I'm on the switch I cannot ping the FW from the far interface on the switch:
xxxx-02#ping 10.63.7.6 source 10.63.7.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.63.7.6, timeout is 2 seconds:
Packet sent with a source address of 10.63.7.2
.....
Success rate is 0 percent (0/5)
xxxx-02#ping 10.63.7.6 source 10.63.7.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.63.7.6, timeout is 2 seconds:
Packet sent with a source address of 10.63.7.5
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/8 ms
xxxx-02#sh ip int brie
Interface IP-Address OK? Method Status Protocol
Vlan1 unassigned YES NVRAM administratively down down
Vlan10 10.63.0.1 YES NVRAM up up
Vlan101 unassigned YES NVRAM down down
Vlan102 10.63.2.1 YES NVRAM up down
Vlan103 10.63.3.1 YES NVRAM up down
Vlan104 10.63.4.1 YES NVRAM up down
Vlan105 10.63.5.1 YES NVRAM up up
Vlan106 10.63.6.1 YES NVRAM up up
Vlan107 unassigned YES NVRAM down down
FastEthernet0 unassigned YES NVRAM administratively down down
GigabitEthernet1/0/1 10.63.7.2 YES NVRAM up up
GigabitEthernet1/0/2 10.63.7.5 YES NVRAM up up
Here is the switch side:
interface GigabitEthernet1/0/1
description UPLINK BowlingGreen-3845 gi0/0
no switchport
ip address 10.63.7.2 255.255.255.252
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
queue-set 2
priority-queue out
mls qos trust cos
auto qos voip trust
spanning-tree portfast
!
interface GigabitEthernet1/0/2
no switchport
ip address 10.63.7.5 255.255.255.252
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
queue-set 2
priority-queue out
mls qos trust device cisco-phone
mls qos trust cos
auto qos voip cisco-phone
spanning-tree portfast
service-policy input AutoQoS-Police-CiscoPhone
!
ip routing
ip route 0.0.0.0 0.0.0.0 10.63.7.6
ip route 10.0.0.0 255.0.0.0 10.63.7.1
ip route 10.63.4.192 255.255.255.192 10.63.7.6
ip route 10.254.254.0 255.255.255.0 10.63.7.6
ideas?
