Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Even when I'm on the switch I cannot ping the FW from the far interface on the switch:xxxx-02#ping 10.63.7.6 source 10.63.7.2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.63.7.6, timeout is 2 seconds:Packet sent with a source add...
I tried creating a privilege 0 account for a client for read-only access to their ASA firewalls. For the CLI login, it won't matter cause they don't know the enable password, so that keeps them from making changes. But for the ASDM login, I was ab...
I tried creating a privilege 0 account for a client for read-only access to their ASA firewalls. For the CLI login, it won't matter cause they don't know the enable password, so that keeps them from making changes. But for the ASDM login, I was ab...
Hello all,I'm trying to upgrade the IPS sig's on an ASA5520 with a SSM IPS module. I'm trying to upgrade the system to 5.1.1 to further upgrade the device with no luck. I followed these steps provided by Cisco.com: 1. Log in to the ASA. 2. Enter e...
Hey I'm bout to install a 6500 series with 2 SUP engines, one for primary and one for backup in the same chassis.My question is: Do the fiber/GIG ports on the backup SUP engine work, when it is in backup mode, or ONLY when the SUP engine is in prima...
Fixed it!:aaa new-modelaaa group server tacacs+ TACACSGROUP server-private 10.1.2.149 port 49 key 7 002906xxxA03 ip vrf forwarding Chmbr-General ! This is to be omitted for devices without VRF's ip tacacs source-interface GigabitEthernet0/0.9!aaa au...
I'm having the same issue with a router running: c2800nm-advipservicesk9-mz.124-15.T1.binThe config is as follows:aaa new-model!!aaa group server tacacs+ TACACSGROUP server-private 10.1.2.49 port 49 key 7 143A070718xxxxx26616572000156 ip vrf forwardi...
I've been through MANY FAX problems with tons of Cisco hardware...make suremgcp fax protocol cisco is not on....my SOP i wrote for my self:http://chrisserafin.com/Tutorial-vg248.doc
I'm having problems with 'route null0' statics being propagated through our MPLS / EIGRP / BGP network even when I do not have default-info-originate commands under the routing protocolsCisco80211Chris SerafinIT Security / Cisco VoIP Engineerchris@ch...
