10-21-2008 10:39 AM - edited 03-06-2019 02:03 AM
I have 4 WS-C3750-24TS-S in stack. The command "show cpu history" shows in the 72 hour table cpu load of 100% instances. However I,m monitoring the cpu load with rmon and the alarm never fires. My high level threshold is set at 60%.
I tested the rmon by setting the threshold at 5%. this works fine.
Can anyone help me with this?
Thanks in advance.
10-29-2008 03:16 PM
RMON is disabled by default; no alarms or events are configured.
Only RMON 1 is supported on the switch.
To verify use this commands.
Switch# show interfaces interface-id transceiver detail
For further information about configuring the Rmon Alarm & Events click this link.
10-30-2008 01:03 AM
Thanks for your reply. However the rmon not working isn't the issue. When I lower my threshold rmon works fine. The real issue is the high cpu load in the "72 hour"table on my 3750 stack and rmon doiing nothing with it.
10-30-2008 11:45 AM
This will sound crazy, but I have seen issues where a bad conector cable has caused VERY high CPU utilization rates.
HTH,
Brandon
10-30-2008 12:31 PM
Hi Brandon. It doesn't sound crazy to me. I will check the cabling.
Thnx
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide