12-18-2019 02:48 AM
Hello.
I have connected 2 3750's togeather to make a stack, it shows one as master and the other as Member, is that the same as Master and Slave? or is Member somethiing different?
Also the stack light does not show on? any ideas on this?
Kind Regards,
Chris
12-18-2019 03:11 AM - edited 12-18-2019 03:11 AM
Hi there,
Slave/ member denote exactly the same stack membership status.
The stack LED is only lit once you press the MODE button a 'few' times. Once it is lit solid green you will then notice the switchport LEDs (1-9) light up. The flashing number will denote the stack number of the switch.
Read the 'Stack LED' section here:
cheers,
Seb.
12-18-2019 07:42 AM
Hello
thats correct - if you also check the stack port and ring speed it should denote that the stacking is fine and you either have a half -full stack ring
sh switch stack-ports
sh switch stack ring speed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide