Can you configure one switch with an IP address to be the stack master and leave the remainder of the switches with no configuration? Or, could you configure all of the switches with the same configuration so that if the existing stack master fails the newly elected master will have the same configuration?
At what distance does SFP GLC-LH-SMD work?
Recently I had a conversation with a colleague. Between the two buildings installed SM optic cable. Length is about 15 km, attenuation is about 8 dB. I say, we will install SFP LX and it will work. The colleague ...
EEM script to capture packets at SPP every 15 mins and other logs every minute.
Following o/ps are captured every minute:
show drops all location all
sh controllers np counters all location 0/0/cpu0
sh controllers np counters all l...
What is the best way to bridge the gap between business requirements and what a network can deliver? The answer is clear: Intent-based networking for the WAN. We know the journey is long and ongoing, but the good news is that the closer we get, the faster...
Whenever we create tunnel interfaces, the GRE IP MTU is automatically configured 24 bytes less than the outbound physical interface MTU. Ethernet interfaces have an MTU value of 1500 bytes. Tunnel interfaces by default will have 1476 bytes MTU. 24...