3750 Switch Stack Configuration

[Korimarchana]

Hello All,

I am new to networking and I am learning switch stacking configuration.I am having following having issues.

(Both switches are compatible to each other)

• show switch stack-ports summary" command showed the port status as "absent" (indicating no cable detected on stack port even though Cable screws are tightened properly)
  

Switch-2A# show switch stack-ports summary

Switch#/ Stack Neighbor Cable Link Link Sync # In
Port# Port Length OK Active OK Changes Loopback
Status To LinkOK
-------- ------ -------- -------- ---- ------ ---- --------- --------
1/1 Absent None No cable No No No 0 Yes

• "show switch" command only detects "master", not the slave or the member
  

Switch-2A#en show switch
Switch/Stack Mac Address : e8b7.4843.1f00
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master e8b7.4843.1f00 1 1 Ready

Help me figuring out what is going wrong int the configuration.

Thank You,

Archana

[Reza Sharifi · Accepted solution]

Hi,

Can you try using a different stacking cable and test again?

HTH

[Korimarchana]

Thanks for your response.

It worked after changing the cable.

[Reza Sharifi]

Can you rate and mark the post as answered, so others can benefit from it?

Thanks