3750G Switch with PBR with IP SLA - Not working !!!

Mubasher Sultan - 2x CCIE # 20149 (R&S | Sec) · ‎10-09-2012

Hi,

I am having a switch 3750G (WS-C3750G-24TS-S) running a software version (c3750-ipservicesk9-mz.122-55.SE6.bin) and using the PBR with IP SLA.

While, i am applying it on interface, it says not supported....

route-map TO-CAS-E0 permit 10

match ip address 125

set ip next-hop verify-availability 10.116.199.200 10 track 100 (if i change this command to set ip next-hop 10.116.199.200, it works)

!

WAN-L3-3750SW01(config-route-map)#interface GigabitEthernet1/0/11

WAN-L3-3750SW01(config-if)#ip policy route-map TO-CAS-E0

WAN-L3-3750SW01(config-if)#

22:49:06: %PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map TO-CAS-E0 not supported for Policy-Based Routing

WAN-L3-3750SW01(config-if)#

!

Relevant configuration is attached...

Kindly, let me know that any alternative solution to use the PBR with IP SLA....

Thanks,

Regards,

Mubasher Sultan

Harish Balakrishnan · ‎10-09-2012

Hello Mubashir,

37xx doesnt support this option.. However the below thread gives you some information, on what you are trying to achieve

https://supportforums.cisco.com/docs/DOC-8069

harish.

AhmedSonba · ‎10-09-2012

Hello mubashir

I have just tried your configuration on my university Cisco Lab just right now and it did not work as you said and googled your error message and it turned out it is a hardware limitation

Which means that the route-map attached to an interface for policy routing contains an action that is not supported on this platform.

One work around is to make this action Routing this action

please the refer the follwoing link for more information

https://supportforums.cisco.com/docs/DOC-8313

It will make the same result " just an Idea"

Hope it will help

Ahmed Sonab