I have some questions on flow control, more in particular on a 3850 switch.
- Can someone clarify the difference between: "flowcontrol receive on" and "flowcontrol receive desired"? The config guide of the 3850 does not help a lot.
- I have configured "flowcontrol receive on" on an interface but I see the following output, can someone clarify why this is happening? Why do I see "Recieve admin" to on and "FlowControl oper" to off?
show int gi 1/0/38:
input flow-control is off, output flow-control is unsupported
show flowcontrol interface gigabitEthernet 1/0/38:
Port Send FlowControl Receive FlowControl RxPause TxPause admin oper admin oper --------- -------- -------- -------- -------- ------- ------- Gi1/0/38 Unsupp. Unsupp. on off 50 0
Hi all,I´d like to get a better understanding of 802.1X and therefore I`d like to know if it`s a common scenario to use 802.1X to authenticate an Access-Point (probably in a deployment where the AP can be physically accessed by guests or so...) and afterw...
Cisco Digital Network Architecture Center Tools <Template Editor > In this article, we are going to talk about the Cisco Digital Network Architecture Center Template Editor tool.Cisco DNA Center gives us the flexibility and scalability to confi...
Community Live- Cisco SD-WAN Policies: Leveraging the Full Power of Cisco SD-WAN
(Live event - formerly known as Webcast- Tuesday 24 March, 2020 at 10 am Pacific/ 1 pm Eastern / 6 pm Paris)
This event had place on Tuesday 24th, March 2020 at 10hrs P...
IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches. Tha...
Hello,I'm needing to integrate the Cisco Firepower 2110 into our Data Center JUST to fulfill Site-to-Site and Remote Access VPN. My SD-WAN ISRs already have FW and IPS running, which is what I want since I have internet breakouts at my branches, so this D...