4 port and 8 port switch module in Cisco 1941 router

[brobinb]

Hi there,

My questions is can a 4 port PoE switch module (EHWIC-4ESG-P) and a 8 port switch module (EHWIC-D-8ESG) be used at the same time in a Cisco 1941 router?

Thanks in advanced.

Robin

[Reza Sharifi]

Hi,

No, the EHWIC-D-8ESG is double-wide and so you can only put one double-wide or 2 single-wide.

From the data sheet:

Two integrated EHWIC slots are available on the  Cisco 1941 for flexible configurations for support of two modules: One  double wide HWIC-D or single wide EHWIC/HWIC module and a second single  wide E-HIC/HWIC module are supported.

see table-3 in this link:

http://www.cisco.com/en/US/prod/collateral/routers/ps10538/data_sheet_c78_556319.html

HTH