4948 VRF and WCCP

[aovp77]

Hello,

Does anyone know if  a Cisco Catalyst 4948-10GE running VRF will also support WCCP?

The IOS version is 12.2(53)SG2

Thanks in advance.

James.

[Reza Sharifi · Accepted solution]

Hi James,

It is not supported.

Below message says, it is not supported in 12.2(54), so I am assuming it is not supported in earlier versions like 12.2(53)

Unsupported Features

These features are not supported in Cisco IOS Release 12.2(54)SG for the Cisco Catalyst 4948E Ethernet Switch and the Catalyst 4900M series switch:

•MAC notification MIB support

•RPR

•NSF with SSO

•ISSU

•The following ACL types:

–Standard Xerox Network System (XNS) access list

–Extended XNS access list

–DECnet access list

–Protocol type-code access list

•ADSL and Dial access for IPv6

•AppleTalk EIGRP (use native AppleTalk routing instead)

•Bridge groups

•CEF Accounting

•Cisco IOS software IPX ACLs:

–<1200-1299>       IPX summary address access list

•Cisco IOS software-based transparent bridging (also called "fallback bridging")

•Connectionless (CLNS) routing; including IS-IS routing for CLNS. IS-IS is supported for IP routing only.

•DLSw (data-link switching)

•IGRP (use EIGRP instead)

•IP SLA

•isis network point-to-point command

•Kerberos support for access control

•LLDP HA

•Lock and key

•NAT-PT for IPv6

•Reflexive ACLs

•Routing IPv6 over an MPLS network

•Two-way community VLANs in private VLANs

•WCCP v1 and v2

•PIM Stub in IP Base

•UniDirectional Link Routing (UDLR)

•NAC L2 IP - Inaccessible authentication bypass

•Packet Based Storm Control

•AutoQoS - VoIP

•Global QoS (enable QoS)

•CER for E-911 Support

•Auto RP

•Cisco-Port-QoS-MIB

•Real Time DiagNosis (GOLD-Lite)

•Time Domain Reflectometry

•HTTP Software Upgrade

•MAC Address Notification

•CFM CoS

Here is the doc

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_15594.html

HTH

[aovp77]

Hi HTH,

Thank you for your reply.

I have also found via Cisco feature navigator that WCCP per VRF is not supported on any Catylst switches.

Regards,

James