Switching

Hi,I have a 3560 switch and when it is booting send the following error:Unexpected exception to CPUvector 2000, PC = 4BA99C-Traceback= 4BA99C 4BA98C F17D10 F17DB0 AA3A48 AA3DCC 864AE8 85ED2CWriting crashinfo to flash:crashinfo_19930301-000003=== Flus...

Hi I have configured my cisco switch with archiving commands mentioned below in order to get notification about any change config happen on the switch. I can see the hange notification messages is showing on the log but sys log server doesn't receiv...

If an access switch is only connected to one 6509 distribution switch that is running HSRP and the port goes down can  the access switch connected to that port down still find a way to foward packets accross the trunk link to the other distribution a...

If the port 2 on one of the stackable switch goes down does the server connected to that bad port still have connectivity through other the stackable switches also one thing I need to mention is that the stackable switch that has that port 2 bad is s...

Hello,I have two 3750 stackable switches, if one switch goes down, do the computers connected to that bad switch virtually connect to the network through the other switch, or do you need three 3750 stackable switches for this theory to take effect.  ...

Dear all,could you please some one help me that i connected cisco 3560G switch and huawei S9303 model series point to point utp cable and tried to ping continously but often i get packet drops.I tried both devices as auto with auto speed but still sa...

I the following setup:switch1 -->                  switch3 --> C2800 --> ASA --> Internetswitch2 -->the switches are C3560's.I would like to limit some ports on all 3560's to 2MG to the Internet (both ways) and drop all traffic surpassing that limit....

after the boot up of the Switch SyStem Led is Orange and not Green, any paticular reason Why.Thanks for the help

hello everyone, i have been searching the forums for quite some time and can't get the answer i'm looking which embarasses me, i have a fair understanding of networking, yet this is my first experience in the cisco/business networking area.what i am ...

On the Cisco switches (2960) can I apply layer 2 COS marking inbound on a Dot1q trunk, or can it be applied outbound only. I understand when a Frame comes inbound on a Trunk, the Vlan tag is removed, so dot1p cos cannot be applied. On the outbound, t...

Hi folks ,I desperately need help from you all here,I tried to  upgrade my switch 2900xl series ,but I upload the tar format of the ios  without using the appropriate command and it didn't obviously work then  I  deleted it and now I want to load bac...