Hi,
You can try the below command.
Below is the sample sprom output
test1> (enable) sh sprom 4/13
GBIC Serial EEPROM Contents:
Common block:
Identifier : GBIC [0x01]
Connector : RJ45 connector [0x00]
Transceiver
Speed : [0x00]
Media : [0x00]
Technology : [0x00]
Link Length : [0x08]
GE Comp Codes : [0x00]
SONET Comp Codes : [0x00]
Encoding : 8B10B [0x01]
BR, Nominal : 0x100 MHz [0x00]
Length(9u) : GBIC does not support single mode fibre,
or the length information must be determined from
the transceiver technology. [0x00]
Length(50u) : GBIC does not support 50 micron multi-mode fibre,
or the length information must be determined from
the transceiver technology. [0x00]
Length(62.5u) : GBIC does not support 62.5 micron multi-mode fibre,
or the length information must be determined from
the transceiver technology. [0x00]
Length(Copper) : 100 m [0x64]
Vendor Name : CISCO@SYSTEMS
Vendor OUI : 0x20 0x20 0x20
Vendor PN : WS-G5483
Vendor rev :
CC_BASE : 0x89
Extended ID Fields
Options : Loss of Signal implemented TX_DISABLE is implemented and di
sables the serial output
BR, max : Unspecified
BR, min : Unspecified
Vendor SN : FHH1208T14X
Date code : 001215
CC_EXT : 0x31
Vendor Specific ID Fields:
87fd5008 00 00 07 19 1F 74 E6 5D 8D 09 D8 60 20 26 17 9A .....t.]...` &..
87fd5018 4F 02 2D 00 00 00 00 00 00 00 00 00 4F 06 25 16 O.-.........O.%.
Various sprom commands:
======================
CatOS844> (enable) sh sprom
Usage: show sprom [sprom_num] [dump]
show sprom sup [mod_num] [dump]
show sprom earl [mod_num] [dump]
show sprom chassis [dump]
show sprom powersupply <1|2> [dump]
show sprom clock <1|2> [dump]
show sprom vtt <1|2|3> [dump]
show sprom fan <1|2> [dump]
show sprom [dump]
Hope this helps
Cheers
Somu
Rate helpful posts
