I hope somebody can help me, I am trying to configure a 6509 as the passive receiver from a Dell Force10 10Ge switch with 2 sfp to 2 gig ports on our 6509 switch, I see LACP is up on both sides but cannot pass traffic, I have only 2 vlans that will carry across the aggregate link from our vmware boxes, this is just a temp until I get a 10ge in our 6509 chassis.
Attached is the config on both sides.
Make sense?
-------------------------------------------------------
Cisco 6509 Config
-------------------------------------------------------
interface GigabitEthernet6/7
switchport
no ip address
spanning-tree portfast
switchport mode trunk
channel-protocol lacp
channel-group 1 mode active
!
interface GigabitEthernet6/8
switchport
no ip address
spanning-tree portfast
switchport mode trunk
channel-protocol lacp
channel-group 1 mode active
interface Port-channel1
description lacp Force10
switchport
switchport trunk encapsulation dot1q
Switchport mode trunk
no ip address
logging event link-status
--------------------------------------------------------
-----------------------------------------------------------------------------------
show etherchannel detail
-----------------------------------------------------------------------------------
Channel-group listing:
-----------------------
Group: 1
----------
Group state = L2
Ports: 2 Maxports = 16
Port-channels: 1 Max Port-channels = 16
Protocol: LACP
Minimum Links: 0
Ports in the group:
-------------------
Port: Gi6/7
------------
Port state = Up Mstr In-Bndl
Channel group = 1 Mode = Active Gcchange = -
Port-channel = Po1 GC = - Pseudo port-channel = Po1
Port index = 0 Load = 0x55 Protocol = LACP
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Gi6/7 SA bndl 32768 0x1 0x1 0x607 0x3D
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
Gi6/7 FA bndl 32768 0x0 0x1 0xA5 0x3F
Age of the port in the current state: 0d:00h:08m:06s
Port: Gi6/8
------------
Port state = Up Mstr In-Bndl
Channel group = 1 Mode = Active Gcchange = -
Port-channel = Po1 GC = - Pseudo port-channel = Po1
Port index = 1 Load = 0xAA Protocol = LACP
Flags: S - Device is sending Slow LACPDUs F - Device is sending fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Local information:
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Gi6/8 SA bndl 32768 0x1 0x1 0x608 0x3D
Partner's information:
Partner Partner LACP Partner Partner Partner Partner Partner
Port Flags State Port Priority Admin Key Oper Key Port Number Port State
Gi6/8 FA bndl 32768 0x0 0x1 0xA4 0x3F
Age of the port in the current state: 0d:00h:08m:06s
Port-channels in the group:
----------------------
Port-channel: Po1 (Primary Aggregator)
------------
Age of the Port-channel = 1d:01h:24m:05s
Logical slot/port = 14/1 Number of ports = 2
Port state = Port-channel Ag-Inuse
Protocol = LACP
Ports in the Port-channel:
Index Load Port EC state No of bits
------+------+------+------------------+-----------
0 55 Gi6/7 Active 4
1 AA Gi6/8 Active 4
--------------------------------------------------------------------------------
----------------------------------------------------------------------------------------------
Force 10 Config
----------------------------------------------------------------------------------------------
interface TenGigabitEthernet 0/24
description LAG to VMWARE servers
no ip address
!
port-channel-protocol LACP
port-channel 2 mode active
no shutdown
!
interface TenGigabitEthernet 0/25
description LAG to VMWARE servers
no ip address
!
port-channel-protocol LACP
port-channel 2 mode active
no shutdown
interface TenGigabitEthernet 0/34
description LAG to Cisco 6905
no ip address
!
port-channel-protocol LACP
port-channel 1 mode active
no shutdown
!
interface TenGigabitEthernet 0/35
description LAG to Cisco 6905
no ip address
!
port-channel-protocol LACP
port-channel 1 mode active
no shutdown
interface Port-channel 1
description LAG to Cisco 6905
no ip address
switchport
no shutdown
!
interface Port-channel 2
description LAG to VMWARE Servers
no ip address
switchport
no shutdown
!
interface Vlan 1
!
interface Vlan 2
name VMWARE Data VLAN
no ip address
tagged Port-channel 1-2
no shutdown
!
interface Vlan 4
no ip address
tagged Port-channel 1-2
no shutdown
---------------------------------------------------------
--------------------------------------------------------------
AIS-Prod-1#sh lacp 1
--------------------------------------------------------------
Port-channel 1 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e88b.52b8
Partner System ID: Priority 32768, Address 00d0.0345.8800
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled
L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
O - Receiver is in expired state, P - Receiver is not in expired state
Port Te 0/34 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 32768
Oper: State ACEGIKNP Key 1 Priority 32768
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State ADEGIKNP Key 1 Priority 32768
Port Te 0/35 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 32768
Oper: State ACEGIKNP Key 1 Priority 32768
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State ADEGIKNP Key 1 Priority 32768
---------------------------------------------------------------
------------------------------------------------------------------
AIS-Prod-1#sh lacp 2
------------------------------------------------------------------
Port-channel 2 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e88b.52b8
Partner System ID: Priority 65535, Address ac16.2d73.1cdc
Actor Admin Key 2, Oper Key 2, Partner Oper Key 11
LACP LAG 2 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled
L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
O - Receiver is in expired state, P - Receiver is not in expired state
Port Te 0/24 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 2 Priority 32768
Oper: State ACEGIKNP Key 2 Priority 32768
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State ADEGIKNP Key 11 Priority 255
Port Te 0/25 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 2 Priority 32768
Oper: State ACEGIKNP Key 2 Priority 32768
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State ADEGIKNP Key 11 Priority 255
Thanks
Mike
