Hi all
We have a 76-ES+XC-40G3CXL module installed in a 7606-s Chassis w/ RSP720-3C-GE and 2x PSU PWR-2700-AC.
During boot up getting an error:
_________________________________________________________________________________
*Jan 1 00:10:06.515: %DIAG-SP-6-RUN_MINIMUM: Module 1: Running Minimal Diagnost
ics...
*Jan 1 00:10:11.839: %MLSCEF-DFC1-2-FIB_TCAM_WRITE_INCONSISTENCY: FIB TCAM Mism
atch for value: Index: 0
Expected: Entry: 0x00-0x00000000-0x00000000
Hardware: Entry: 0x00-0x00000400-0x10000000
*Jan 1 00:10:12.179: %SYS-DFC1-2-NOBLOCK: printf with blocking disabled. -Proce
ss= "TYFIB Table Manager", ipl= 5, pid= 155
-Traceback= 81C1058z 83E7118z 9299A9Cz 9299C00z 85B63ECz 93B9048z 93B9364z 93A7A
28z
*Jan 1 00:10:19.575: %PM_SCP-SP-1-LCP_FW_ERR: System resetting module 1 to reco
ver from error: x40g_crashinfo_init: Linecard received system exception
*Jan 1 00:10:19.575: %OIR-SP-3-PWRCYCLE: Card in module 1, is being power-cycle
d Off (Module Reset due to exception or user request)
*Jan 1 00:10:19.687: %C7600_PWR-SP-4-DISABLED: power to module in slot 1 set Of
f (Module Reset due to exception or user request)
*Jan 1 00:11:30.647: %FABRIC_INTF_ASIC-DFC1-5-FABRICSYNC_DONE: Fabric ASIC 0 Ch
annel 1: Fabric sync done.
*Jan 1 00:11:30.679: %FABRIC_INTF_ASIC-DFC1-5-FABRICSYNC_DONE: Fabric ASIC 1 Ch
annel 1: Fabric sync done.
*Jan 1 00:11:33.315: %DIAG-SP-6-RUN_MINIMUM: Module 1: Running Minimal Diagnost
ics...
_______________________________________________________________________________________
It's repeating over and over. Any help would be greatly appreciate it!
show logging attached.
