876 Vlan's

[rpmsnepvangers]

Hello

I have a Cisco 876 router. I have created an extra VLAN, number 2. I have assigned an IP adress and 2 ethernet ports.

For the IP adress of VLAN1 is automaticly an IP route created (C = connected). For VLAN2 this is not?! I also can't create an static route to the IP adress of VLAN2.

What am I doing wrong?

[aijaz802]

Hi,

Make sure that its not shutdown, do a "no shut" under vlan 2.

rate this if it helps...

Thanks..

*aijaz*

[rpmsnepvangers]

Hi,

Sorry for the late reaction, but unfortunatly is does not work.

This a part of my config

interface Vlan1

description CustomerLAN

ip address 192.168.10.253 255.255.255.0

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1452

!

interface Vlan2

description AtlanticLAN

ip address 192.0.2.254 255.255.255.0

ip nat inside

ip virtual-reassembly

ip tcp adjust-mss 1452

This is my IP route table

Gateway of last resort is not set

C 192.168.10.0/24 is directly connected, Vlan1

10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks

S 10.20.1.0/24 [1/0] via 10.200.0.1

C 10.200.0.0/30 is directly connected, Dialer0

Can you help me further??

Greetz Richard

[bimckenz]

Are any of the switchports assigned to vlan 2 up? If you show ip int brief, is VLAN 2 down/down?

[aijaz802 · Accepted solution]

Hi,

Connect at least one device in Vlan2 access ports and check, it should come up.

Cisco 876 supports upto 2 vlans with base image and upto 4 vlans with advance IP services image. If you have any other vlans, please remove/shutdown them.

Regards,

*aijaz*

[rpmsnepvangers]

Hi, yes this is the solution!

I only prepared the router. As soon as 1 FastEthernet link was on, the route was added.

It is removed as soon as the link is down.

Thank you for your help

greetz,

Richard