Hi,
I cannot see any logging messages indicating that some packets meeets the Access-list condition. Here is a portion of the configuration:
logging console informational
interface GigabitEthernet1/0/3
ip access-group 101 in
access-list 101 deny icmp any any log
Note: I know that this ACL is working since I cannot ping the VLAN from my PC.
Is there anything missing in order to see some messages indicating that some packet meets the ACL condition. Also would like to know where the messages displays by the Console and buffer logging are logged.
Thanks for your help
Stephane
R1#show logging
Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes,
0 overruns, xml disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
Console logging: level informational, 231 messages logged, xml disabled,
filtering disabled
Monitor logging: level debugging, 0 messages logged, xml disabled,
filtering disabled
Buffer logging: level debugging, 231 messages logged, xml disabled,
filtering disabled
Exception Logging: size (4096 bytes)
Count and timestamp logging messages: disabled
File logging: disabled
Persistent logging: disabled
No active filter modules.
Trap logging: level informational, 230 message lines logged
Log Buffer (4096 bytes):
8w6d: %SYS-5-CONFIG_I: Configured from console by console
8w6d: %SYS-5-CONFIG_I: Configured from console by console
