01-14-2014 06:21 AM - edited 03-07-2019 05:33 PM
Hi..
switch1#sh authentication sessions interface Gi4/0/20 details
Interface: GigabitEthernet4/0/20
IIF-ID: 0x103B1C000001077
MAC Address: 00e0.c537.9e2d
IPv6 Address: Unknown
IPv4 Address: 10.101.233.78
User-Name: INV000000155986.ads.sfa.se
Status: Authorized
Domain: DATA
Oper host mode: multi-auth
Oper control dir: in
Session timeout: 28800s (server), Remaining: 28532s
Timeout action: Reauthenticate
Common Session ID: 0AC9F1080007C27169370036
Acct Session ID: 0x0007DD1A
Handle: 0x6C000E8A
Current Policy: POLICY_Gi4/0/20
Server Policies:
ACS ACL: xACSACLx-IP-IGEL-ACL-5297633a
Method status list:
Method State
dot1x Authc Success
mab Stopped
switch1#
switch1#sh ip access-lists interface Gi4/0/20
switch1#
on old switch:
switch_2#sh ip access-lists interface Gi1/0/12
permit icmp host 10.180.103.229 any echo-reply
permit udp host 10.180.103.229 host 192.168.40.11 eq ntp
permit udp host 10.180.103.229 any eq bootps
permit udp host 10.180.103.229 any eq bootpc
permit udp host 10.180.103.229 any eq domain
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq smtp
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq www
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 443
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 5000
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 4070
permit tcp host 10.180.103.229 any eq 5001
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 3269
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 3268
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 88
permit udp host 10.180.103.229 eq snmp 192.168.146.32 0.0.0.31
permit udp host 10.180.103.229 192.168.146.32 0.0.0.31 eq snmptrap
permit udp host 10.180.103.229 192.168.146.32 0.0.0.31 eq ntp
permit udp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 464
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 464
permit udp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 135
permit tcp host 10.180.103.229 192.168.146.32 0.0.0.31 eq 135
permit tcp host 10.180.103.229 10.180.0.0 0.0.255.255 eq 9100
permit tcp host 10.180.103.229 10.140.70.0 0.0.0.255 eq 9100
permit udp host 10.180.103.229 10.180.0.0 0.0.255.255 eq netbios-ns
permit udp host 10.180.103.229 eq netbios-ns 10.180.0.0 0.0.255.255
permit tcp host 10.180.103.229 10.180.0.0 0.0.255.255 eq 139
permit tcp host 10.180.103.229 10.180.0.0 0.0.255.255 eq 445
permit tcp host 10.180.103.229 any established
01-14-2014 07:16 AM
I'm not sure if that command is supported or not, I did a click look on a 3850 Cisco Configuration Guide and found the following.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide