ACE Module Configuration
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2007 01:37 AM - edited 03-05-2019 02:47 PM
Hi, can anyone point me in the right direction for documentation on how to configure the new ACE module for the 6500. In particular how to configure an ACE context in router mode to load balance two servers.
Thanks in advance.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2007 12:45 PM
"Application Networking" is the proper place to ask questions about Cisco's content networking products
You can start from a nice little example at
http://dataplumber.wordpress.com/2006/12/19/sample-config-the-new-cisco-ace-card-for-catalyst-6509/
For more details
hope it helps
Syed Iftekhar Ahmed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2007 11:19 PM
Many thanks.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2007 08:04 PM
Hi,
For ACE documentation as per your software version:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/ace/ace_301/index.htm
Many dont like the fact, but its true that to find documentation on service modules, we need to look under the switch/device platform rather than the technology supported.
Hope it helps.
Regards
Rajat Chauhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2007 11:20 PM
Thanks for the reply
