09-03-2009 10:33 AM - edited 03-06-2019 07:35 AM
Hi, I see that on a 3750, I do 'show access-list' and I can see numbers showing sequence of access-lists.
Then I do this on a 7200 and it appears as below, without numbers. Just wanted to confirm this is an IOS version or whether I can also get the numbers listed via commands?
R0#show access-list
Extended IP access list Yourlist
permit icmp any any
permit ip host 10.13.213.21 any
R0#
09-03-2009 10:50 AM
Hello.
In 12.2 (I don't know the exact release/train) and later it became possible in insert new ACEs in numbered ACLs just like named ACLs. This is why you have sequence numbers against your 'show access-list' command. You can add/change like a numered acl by just starting with the command 'ip access-list 101'
Hope that helps
Simon
09-03-2009 11:07 AM
So it means that if i want to change one entry which is on the bottom of the 'extended myaccesslist' and move it to the top, I would need to edit the entire access-list on notepad, then paste the whole access-lists again?
09-03-2009 12:06 PM
That is correct . Numbered ACL's started with 12.2.xT train I believe . Named ACL's came before that and you could add or delete items but you could not resequence them without modifying like you have said.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide