Any equivalent command to "show storm-control" on Cisco 6800?

[smeroz]

With c3750 it was very easy to display table of multicast levels by executing: "show storm-control multicast". I can't find similar a way to do this with c6800. I'm trying to identify which device caused the storm-control mechanism to send a trap. 

Any other useful commands related to this topic will be also appreciated (maybe related to mroute, mfib etc).

[MHM Cisco World]

show interfaces counters storm-control

please check this command 

[smeroz]

Hi, thanks for your response. This will display a table with the configured levels and the amount of violations but not the current level (The 3750 shows also the current level).

[marce1000]

 - Perhaps :  show storm-control broadcast ,

 M.