Any equivalent command to "show storm-control" on Cisco 6800?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 02:18 AM
With c3750 it was very easy to display table of multicast levels by executing: "show storm-control multicast". I can't find similar a way to do this with c6800. I'm trying to identify which device caused the storm-control mechanism to send a trap.
Any other useful commands related to this topic will be also appreciated (maybe related to mroute, mfib etc).
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 03:27 AM
show interfaces counters storm-control
please check this command
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 05:10 AM
Hi, thanks for your response. This will display a table with the configured levels and the amount of violations but not the current level (The 3750 shows also the current level).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 03:48 AM
- Perhaps : show storm-control broadcast ,
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2023 05:11 AM
Hi, thanks for your response. This command is not available with C6800.
