cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
24267
Views
0
Helpful
6
Replies

Blinking orange light on ports

tianwen.zhao
Level 1
Level 1

Hello everyone,

 

I found several ports blinking orange all the time. The other ports are blinking green normally.

 

GigabitEthernet2/0/11 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 2c86.d219.638b (bia 2c86.d219.638b)
Description: office
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseLX SFP
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:02, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 176023518
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 284000 bits/sec, 125 packets/sec
5 minute output rate 2574000 bits/sec, 766 packets/sec
436582203 packets input, 163380252905 bytes, 0 no buffer
Received 7016634 broadcasts (4536236 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4536236 multicast, 0 pause input
0 input packets with dribble condition detected
1207490843 packets output, 840499659809 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out

 

sw-241#sho interfaces statu | in 2/0/11

Port            Name          Status        Vlan   Duplex Speed    Type
Gi2/0/11 link to office  connected   trunk     full      1000    1000BaseLX SFP

 

There is no errors, half-duplex  , drops , I can't find any abnormal place.

Why the port blinking orange? Any suggestions?

 

Thank you for any answers

 

6 Replies 6

Leo Laohoo
Hall of Fame
Hall of Fame
Post the complete output to the command "sh controll e Gi 2/0/11".

Thank you for your reply.
sw-241#sho controllers ethernet-controller gigabitEthernet 2/0/11
Transmit GigabitEthernet2/0/11 Receive
846293832392 Total bytes 163854868903 Total bytes
807786863 Unicast frames 431667278 Unicast frames
799456951800 Unicast bytes 162773227671 Unicast bytes
278727290 Multicast frames 4539071 Multicast frames
33058043063 Multicast bytes 806527226 Multicast bytes
127501908 Broadcast frames 2482298 Broadcast frames
13778837529 Broadcast bytes 275114006 Broadcast bytes
0 System FCS error frames 0 IpgViolation frames
0 MacUnderrun frames 0 MacOverrun frames
0 Pause frames 0 Pause frames
0 Cos 0 Pause frames 0 Cos 0 Pause frames
0 Cos 1 Pause frames 0 Cos 1 Pause frames
0 Cos 2 Pause frames 0 Cos 2 Pause frames
0 Cos 3 Pause frames 0 Cos 3 Pause frames
0 Cos 4 Pause frames 0 Cos 4 Pause frames
0 Cos 5 Pause frames 0 Cos 5 Pause frames
0 Cos 6 Pause frames 0 Cos 6 Pause frames
0 Cos 7 Pause frames 0 Cos 7 Pause frames
0 Oam frames 0 OamProcessed frames
0 Oam frames 0 OamDropped frames
11856156 Minimum size frames 97141 Minimum size frames
539810229 65 to 127 byte frames 118325271 65 to 127 byte frames
101768252 128 to 255 byte frames 215579483 128 to 255 byte frames
36449152 256 to 511 byte frames 25415027 256 to 511 byte frames
19371044 512 to 1023 byte frames 6846783 512 to 1023 byte frames
136162745 1024 to 1518 byte frames 22826142 1024 to 1518 byte frames
368598483 1519 to 2047 byte frames 49598800 1519 to 2047 byte frames
0 2048 to 4095 byte frames 0 2048 to 4095 byte frames
0 4096 to 8191 byte frames 0 4096 to 8191 byte frames
0 8192 to 16383 byte frames 0 8192 to 16383 byte frames
0 16384 to 32767 byte frame 0 16384 to 32767 byte frame
0 > 32768 byte frames 0 > 32768 byte frames
0 Late collision frames 0 SymbolErr frames
177167610 Excess Defer frames 0 Collision fragments
0 Good (1 coll) frames 0 ValidUnderSize frames
0 Good (>1 coll) frames 0 InvalidOverSize frames
0 Deferred frames 0 ValidOverSize frames
0 Gold frames dropped 0 FcsErr frames
0 Gold frames truncated
0 Gold frames successful
0 1 collision frames
0 2 collision frames
0 3 collision frames
0 4 collision frames
0 5 collision frames
0 6 collision frames
0 7 collision frames
0 8 collision frames
0 9 collision frames
0 10 collision frames
0 11 collision frames
0 12 collision frames
0 13 collision frames
0 14 collision frames
0 15 collision frames
0 Excess collision frames

LAST UPDATE 1212 msecs AGO

Thanks

I don't see anything here.
This is an SFP port, right? Does the patch cable go from Duplex to Simplex?

marce1000
VIP
VIP

 

 - Disconnect the(a) port and re-connect it, after it starts blinking orage issue show logging on the switch. Are there any error messages ?

 M.

 



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Thank you for your reply

There is no error messages in show logging

Thanks

 

- Ok, further more 1) Connect a console and followup on console output, watch for error message  2) Better : configure a syslog server, check the syslog server periodically for error messages coming from the switch 3)                       Check the spanning-tree status per-vlan (!)

M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Review Cisco Networking for a $25 gift card