cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1384
Views
0
Helpful
1
Replies

Block port TCP 5061 on L2 switch

Michael Turkstra
Beginner
Beginner

Dear all

 

I need to block port 5061 TCP for a number of users.

When i want to do this in a 2960 switch and i want to apply it gives the error  %ERROR: Port-based ACLs are not supported with this image

 

my ACL is:

access-list 100 deny tcp any any eq 5061
access-list 100 permit ip any any

Interface fa0/1
access-list 100 in

%ERROR: Port-based ACLs are not supported with this image

 

the Main switch is a 3560.

I was thinking to add a ACL there on uplink interface ??


ip access-list extendend TEST
deny tcp host 192.168.1.1 eq 5061 any
permit ip any any

Interface fa0/1
ip access-group TEST in





Does anyone know what is the best option.

Best for me would be if i could block on interface of the 2960 switch.
Just need to block TCP 5061

 

Thanks!!

 

1 Reply 1

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Layer 2 switches don't know how to look at ports.  

 

You need to find a Layer 3 device, like a router or a Layer 3 core switch.


TCP 5061 = SIP (over TLS) protocol.  You sure you want to do this?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers