cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
0
Helpful
5
Replies

bootable url's in boot variable not found or exhausted

arun_6
Level 1
Level 1

bootable url's in boot variable not found or exhausted showing in c9500x switch after factory reset. please provide the solution for this.

5 Replies 5

marce1000
VIP
VIP

 

   - Can you provide an example of such url's and or a screenshot of the problem as you are experiencing it ?

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

1000076900.jpg

screenshot is attached.

 

I am not troubleshooting anything based off a poorly taken screenshot picture. 

Try again.

Leo Laohoo
Hall of Fame
Hall of Fame

If the switch is in ROMMON, post the complete output to the following commands: 

dir flash:
set

If the switch has correctly boot up, post the complete output to the following commands: 

sh boot
sh romvar
dir

arun_6
Level 1
Level 1

The issue was resolved post booting ios from usb in rommon mode.

Review Cisco Networking for a $25 gift card