Hi,
According to documentation on 2960x it supports Bridge Assurance on RSTP or MST networks. However, I cannot find any of the commands shown in the docs (page 32-33).
I recently connected a Nexus 3000 switch to a 2960x (IOS 15.0(2)) and Bridge Assurance on the Nexus blocked the port. I changed the config on the port from type network to normal and the block was lifted. So the 2960x does not seem to run Bridge Assurance, but I can't enable it either.
Why can't I find the commands on the 2960x? The switch has UDLD configured, should that config be removed if Bridge Assurance is used?