C1000 to C1000 SPF+ C1000-48P-4X-L

IT2022 · ‎06-22-2022

Hello,
we want to connect two C1000-48P-4X-L switches over fiber and are using the following transceivers (10GTek 10G SFP+ SR Multimode Modul - 10GBase-SR LC Transceiver Kompatibel für Cisco SFP-10G-SR).
Transceivers are shown and recognized but do the LEDs by the GBICs have to blink and what type of port do we have to configure, we have set trunk.

Regards

marce1000 · ‎06-22-2022

- For starters, have an in-depth check of sfp-compatibility with : https://tmgmatrix.cisco.com/

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

IT2022 · ‎06-22-2022

We had a look before we bought the transceivers. The current inserted have the supported IEEE 10GBASE-SR standard.
850nm, 300m MMF.

Is there anything I do miss?

marce1000 · ‎06-22-2022

- If they are not Cisco, success is not guaranteed you may use commands as
no errdisable detect cause sfp-config-mismatch
no errdisable detect cause gbic-invalid

Not sure if that will help

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

IT2022 · ‎07-06-2022

I did connect both switches directly via LC/LC cable and that did work.
Then I moved one switch to the other location, connected via SC/LC - no link is comming up. Then I ran the commands above, wr mem and did a reload on both switches. No link after the restart.

Now I guess it could be something with the inhouse lwl cable but it was tested already by lwl technician.
Maybe the lengh is too high? I have no further ideas.