Does anyone have experience of the following please?
C3550 allows the creation of a vrf and all seems to work ok from a routing perspective however clients within the vrf cannot obtain an IP address from dhcp on the switch.
The dhcp pool is created. There is no option to specify vrf within the pool "ip dhcp use vrf connected" does not exist either. Other scopes exist which are not in the new vrf and they work ok.
Sniffer traces show that the switch responded with an offer from the correct scope but from it's native ip address, not the vlan i/f within the relevent vrf. when the client responds to the offer there is no subsequent confirmation from the switch which seems to have lost track of the fact the client is in a different vrf?
Given the age of the ios i expect an upgrade is required but does anyone know of one that works?
Hello I am getting this following error and get ACTV, XPS and S-PWR LEDs amber then suddenly all LEDs are off: Booting...(use DDR clock 667 MHz)*** Coprocessor Unusable Exception ***PC = 0x00000000 00000000SP = 0x00000000 00000000Cause Reg...
Once Cisco DNA Center has provisioned the SD-Access devices to sites, the SD-Access fabric can be created. In the Cisco DNA Center UI, navigate to Provision > Fabric. This is where you create and manage your fabric domains and transits.]
Provision Discovered Devices
On the Cisco DNA Center UI, navigate to Provision page
Select the following devices and provision all the devices to Floor-1. During the provision workflow, Cisco DNA Center can only provision devices of similar family. We wi...