02-07-2020 05:53 AM - edited 02-07-2020 05:54 AM
Hello,
I recently inherited a C6880-X VSS Cluster in one of our buildings for doing maintenance and software upgrade. Nobody really wanted to do it because there are over 400 access ports attached ... But I think it is necessary for security reasons.
Now I don't know how to do it with minimal downtime. Normally I would go the ISSU route but the version difference is too big.
Current version: 15.2.1-SY1a (NPE)
Goal: 15.5.1-SY4 (non-NPE)
Can I go directly from 15.2.1 to 15.5.1 without ISSU or eFSU or do I have to take some steps between? Even with ISSU I have to reload the FEX-Switches... and with ISSU I have to do a lot of steps.
Do you have recommendations?
Any help is appreciated
Thanks!
02-07-2020 06:23 AM
Read the relase noted carefully ( check ROMMON Verson, what you have it may required to upgrade depens on exiting one installed)
The upgrade can be done 2 ways, traditional way :( depends how your FEX connected ? is this dual home or single Homed ?)
Tradional way :
- Copy the IOS to the primary bootflash:
- Copy the IOS to the secondary bootflash:
- Remove the boot variable string pointing to the old IOS
- Add the new boot variable string pointing to the new IOS
- Insert the boot variable string pointing to the old IOS
- Make sure the config-registry is 0x2102
- Save the config
- Reboot ( this means downtime required)
If you go ISSU Route : below guide help you.
02-07-2020 06:37 AM
05-06-2020 12:49 PM
Hi,
I have verified and it seems to me that in the compatibility matrix of the ISSU way there is no upgrade directly from 15.2 to 15.5 so you have to proceed with the traditional way.
Best Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide