C9200 48 p Switch Boot error

[Junak]

when switch was restart and below log.....Please help any one about this issue...............

switch: reset

Are you sure you want to reset the system (y/n)? y
Please wait while the system restarts.

Initializing Hardware...

System Bootstrap, Version 17.8.1r [FC5], RELEASE SOFTWARE (P)
Compiled Wed 01/12/2022 17:11:24 by rel

Current ROMMON image : Primary
C9200-48P platform with 4194304 Kbytes of main memory

switch:

[Leo Laohoo]

If the switch is still in ROMMON, post the complete output to the following commands: 

set
dir flash:

[Enes Simnica]

Hello @Junak 

Your Catalyst 9200 switch is stuck in ROMMON mode after a reboot, and this can fix it:

1. Check Flash Content:
   Run dir flash: to see if the IOS image is present.

2. Set Boot Variable:
   If the image is there, set the boot variable:

   switch: BOOT=flash:/<your_image.bin>

3. Manually Boot:
   Boot the switch with: switch: boot

If the IOS image is missing or corrupt, you'll need to re-upload it.

E.S

[Leo Laohoo]

---

@Enes Simnica wrote:

1. Set Boot Variable:
   If the image is there, set the boot variable:

   switch: BOOT=flash:/<your_image.bin>

---

This response proves even ChatGPT gets it wrong.