02-12-2019 05:35 AM - edited 03-08-2019 05:19 PM
Hi,
I'm currently deploying a test setup with the zero-touch cisco dna center solution.
For this I have deployed:
2x C9300-24T running L3 CAT9K_IOSXE, Version 16.8.1a.
1x C9200
1x DNACenter
However I am already running into issues.
I'm sitting behind a private network, and trying to setup NAT on one of the C9300 series, however it seems like I cannot access or use any L3 commands, such as, natting, routing protocols etc.
As far as I am concerned I have to enable routing functions with "ip routing" however that does help.
The switch have following licenes:
Network-advantage
Dna-advantage
I checked data sheets for C9300 network advantage license and that includes L3 functions.
Currently using sdm template access - I cannot change this? Only option is access.
Any ideas?
These are L3 switches (C9300) and should be able to do routing right?
Solved! Go to Solution.
02-12-2019 06:02 AM
02-12-2019 05:52 AM
02-12-2019 05:55 AM - edited 10-05-2019 07:05 AM
Maybe they need a software update I am not sure about the releases?
Is this what you're looking for?
Switch(config)#ip routing
Switch(config)#ip r?
radius rcmd route routing
rsvp rtcp rtp
Switch(config)#router rip
^
% Invalid input detected at '^' marker.
Switch(config)#
02-12-2019 05:57 AM
02-12-2019 05:59 AM
02-12-2019 06:00 AM
02-12-2019 06:02 AM
02-12-2019 06:05 AM
02-12-2019 06:11 AM
02-13-2019 04:51 AM
02-13-2019 04:53 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide