C9300X-12Y-E Copper 10Gb SFP

[erodriguez@iqteksolutions.com]

Hi,

I have a site that is requesting a 12 port 10Gb switch, I found that the C9300X-12Y-E has what they need but they also need 2 10Gb copper ports, do I need to add a network module?

Thanks

[Flavio Miranda]

erodriguez@iqteksolutions.com 

 You can add C9300-NM-2Q with 2 x 40 giga uplink

[marce1000]

 - Ref : https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-9300-series-switches/nb-06-cat9300-ser-data-sheet-cte-en.html
   If you look at Table 25.   you see that this model does not have copper , but those in the beginning of the table do

  M.

[erodriguez@iqteksolutions.com]

yes, but the customer is requesting a 12 port switch, I see that the GLC-TE is supported, I think this would be an option.

[marce1000 · Accepted solution]

   - You can check compatibilities (copper) SFP's versus device with : 
              Cisco Optics-to-Device Compatibility Matrix

 M.

[erodriguez@iqteksolutions.com]

Thanks it's supported.