C9500 rack installation question (cage nuts & grounding wire)

[AK72495]

We are looking to purchase M6 cage nuts to use for the C9500. Would that work with installing it into the rack? 

For the grounding wire, is there a specific part number that Cisco has for it or do we just use any third-party grounding wire? 

Thank you. 

[Reza Sharifi]

For the grounding wire, is there a specific part number that Cisco has for it or do we just use any third-party grounding wire? 

You can use any third-party grounding wire. It really does not matter what you use as long as it is grounded.

HTH

[AK72495]

Thank you. Do you happen to know anything about the cage nuts? We have a 19-inch SGI rack that is square hole, but the type of switch we are trying to purchase comes with M4 screws (C9500-40X-A). We're just trying to figure out if M6 would work. 

[Reza Sharifi]

When you purchase a rach or cabinet, the cage nuts usually come with it in a plastic bag. If not, to get the right one, I recommend asking the tech support where you purchased it.

HTH