Can I enable AutoQoS on Giga interface on 3925 router ??

[wfchew2007]

Hi all,

I was trying to enable AutoQoS on my router 3925 GE interfaces, but failed to do so !! But I was able to do so on FE interfaces !! I have Security/K9 and Data/K9 license on this router. Or do I still miss out anything ?? I am on IOS 150-1(M4). Please advise.

I was able to enable AutoQoS on all my Cisco 2811 and 1841 routers !!

Best regards,

Lawrence Chew

[cpembleton]

Lawrence,

Your going to have to manually configure a policy for that interface.  Autoqos isn't supported on that interface.

Take a look at this document for interface types autoqos is supported on and other required info to run it. 

http://www.cisco.com/en/US/docs/ios-xml/ios/qos_auto/configuration/15-2mt/qos-auto-15-2mt-book.html

HTH

Chad

[wfchew2007]

Hi Chad,

Thanks for the speedy reply. From the document you provided mostly show low speed interface like serial or ATM and Frame-Relay. I can't see the example on GE interface.

So far I am not able to turn on AutoQoS on my GE router interfaces. No issue on FE interfaces on the same routers.

Best regards,

Lawrence Chew

[cpembleton]

The doc doesn't mention it becuase it's not a supported interface. 

The 3925 only has built-in Gig ports unless your just running them at 100Mbps.  Or do you have a switch module that has your FE interfaces?  Could be that the switch module has support for it similar to regular switch. 

HTH.

Chad