Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Resolved! 3560CG shows 0 traffic in class-map

Hi, QoS expertI tried to put QoS in a  WS-C3560CG-8TC-S  version 12.2(55)EX2.It shows 0 traffic in class-map. Here is the configMy question is why I can not see the traffic via class-map?it should in the default Q if incorrect mark.I erased the confi...

upgrade fwsm from 3.1(10) to 4.1(8)

Hi,I would like to upgrade fwsm from 3.1(10) to 4.1(8).FWSM is install on 6509 and I just upgrade it to s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXH8b.1. Can i upgrade fwsm directly form 3.1(10) to 4.1(8). Or i need to upgrade to 3.2(23) ?2....

Why does Rapid PVSTP mess up everything?

Here is the scenario:When havin only the default VLAN everything works fine.when making a VLAN (Lets say 10) and choosing another switch for that VLAN as the Root Bridge (picture 4 the red line) it messes the whole network up.any ideas where to begin...

Question on tftp over VPN from home...

Interesting scenario developed today...should be simple enough, but.....At home I connect to a Linksys router, that connects to my cox cable modem, to internet.  I was going to try to upload a config remotely for an extreme switch, which its asking f...

6500 trunk to Sonicwall not working

Trunk link not working between 6500 switch and Sonicwall TZ 210 firewall.  I'm trying to trunk 2 vlans from 6500 switch to port on sonicwall to allow Internet access to both vlans.  All vlans are allowed on trunk link currently and on the Sonicwall i...

ACL configuration

Hi all,I want to set ACL for both FTP servers so that both can act as FTP servers, can I set below ACL to acheive it ?Below is the network topologyFTP server A (192.168.0.1)-->RouterA ---Wan link ----Router B ----FTP server B (192.168.1.1)Router A AC...

acbennyma by • Level 1
  • 1304 Views
  • 4 replies
  • 0 Helpful votes

Resolved! stp and diameter

Hi everybody.I am little confused as to how to determine the diameter of a switched network. For e.g my one book defines diameter with in the context of stp as maximum number of  switches a frame has to travel on its way to from source  to destinatio...

sarahr202 by • Level 5
  • 616 Views
  • 2 replies
  • 0 Helpful votes

Resolved! manipulate ospf routing

Hi all, Basically we are having a Multicast setup.  both  A and B offices are being connected with STM-4 (622 Mbps) with IGP as OSPF. As of now everything is working well with this setup and no complaint .Now since Primary link bandwidth is touching ...

Shibu1978 by • Level 1
  • 3902 Views
  • 22 replies
  • 0 Helpful votes

Rapid Spanning Tree in Access Layer?

My colleague and I have been having a discussion about using rapid spanning tree in the access layer.  Most of our infrastructure has been migrated to a routed access layer with 3750s.The idea was brought up to configure the switches with rapid PVST....

how to define static routes

I have my switches behind a Watchguard Firewall- I have 2 vlans set up no trunkingVlan 10 - 10.10.10.1 Vlan 20- 10.10.20.1 I have my servers on Vlan 20 with a Default-Gateway of 10.10.20.1 I have one management server on Vlan 10 with a Default-Gatewa...

Load more