Can LC-SC patch cord connect X2-10GB-SR between SFP-10G-SR ?

[mike kao]

Hi

This is my customer's N7K.

sw7010a2# sh module

Mod  Ports  Module-Type                         Model              Status

---  -----  ----------------------------------- ------------------ ----------

1    32     1/10 Gbps Ethernet Module           N7K-F132XP-15      ok

3    48     10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L     ok

5    0      Supervisor module-1X                N7K-SUP1           active *

6    0      Supervisor module-1X                N7K-SUP1           ha-standby

9    8      10 Gbps Ethernet XL Module          N7K-M108X2-12L     ok

10   8      10 Gbps Ethernet XL Module          N7K-M108X2-12L     ok

The module 1 was no empty port.

Is anybody using LC-SC patch cord connect X2-10GB-SR (on N7K-M108X2-12L) between SFP-10G-SR (on N5K)?

Thanks.

[Reza Sharifi]

Hi,

If your fiber patch is LC to SC (Single Mode) it should work just fine. I have not used LC to SC between Nexus platforams but have used LC to SC to connect 5Ks and 7ks to 6500.

HTH

[Leo Laohoo]

Yes, it'll work fine as long as your fibre patch cord is Multi-Mode.

[ryan.lambert]

Should work just fine as long as it's multi-mode, as stated above.

Also, if there are any jumpers in between, make sure you're not mixing 62.5/50 micron together.

[ashmarkalangottil]

I would like to know which patch cord should I be using between  X2-10GB-SR and IBM 10GBase-SR 10GbE 850 nm Fiber SFP+ Transceiver.

[Reza Sharifi]

You need LC to SC Multimode