12-06-2010 09:56 AM - edited 03-06-2019 02:22 PM
After a powerloss last night one of my networks can no longer access the internet.
The router (Cisco 2901) is configured, and can access the internet, but the server and all the workstations can't ping the gateway.
The network is on a 192.168.4.0 subnet, with the router interface at 192.168.4.1. The server is 4.200 and all the workstations receive dhcp from the server.
The router receives dhcp from the ISP (we're getting static but it hasn't happened yet.)
Everything inside the network works fine, but I can't figure out what is going on when trying to get outside.
Solved! Go to Solution.
12-06-2010 11:43 PM
The only thing I can see is that interface Gig 0/1 does not have an ip address. If this interface is to receive an ip address from your ISP as stated in your post, issue the command ip address dhcp:
Old:
interface GigabitEthernet0/1
no ip address
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
New:
interface GigabitEthernet0/1
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
Based on what I can see with the configuration, is that addresses matching acl 10 are to use Gig 0/1 for translation; however no ip address is assigned to this interface. Possibly this command was entered previously and the memory was not written to.
Cheers,
Daniel
12-06-2010 11:43 PM
The only thing I can see is that interface Gig 0/1 does not have an ip address. If this interface is to receive an ip address from your ISP as stated in your post, issue the command ip address dhcp:
Old:
interface GigabitEthernet0/1
no ip address
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
New:
interface GigabitEthernet0/1
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
Based on what I can see with the configuration, is that addresses matching acl 10 are to use Gig 0/1 for translation; however no ip address is assigned to this interface. Possibly this command was entered previously and the memory was not written to.
Cheers,
Daniel
12-07-2010 04:17 AM
I agree with Daniel.
The one thing im a bit confused about is that you mention that the router can reach Internet?
If so over what interface/vlan? Since your running eigrp is it possible your getting a default route from some other router in your network?
Btw: you mention that servers and workstations cant ping the gateway. Do you mean the 2901 on 192.168.4.1 or an ip in the ISP network?
If they cant ping the 4.1 address you probably lost vlan 2 from a trunk somewhere.
12-07-2010 11:07 AM
Thanks for your help everybody.
I fixed the problem myself. The problem was the switch's configuration got corrupted, or at least part of the configuration did. One of the ports was no longer acting as a trunk and that's why none of the workstations could ping the router, but the router could ping the internet.
Again, thanks for your help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide