cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
637
Views
0
Helpful
3
Replies

Can't access a new Cisco Catalyst 1000 48P Switch

ccabalan
Level 1
Level 1

Hi guys,

 

I'm having trouble accessing a new cisco catalyst 1000 48P-4G-L switch.
Was trying to do a most basic setup so I could upgrade firmware via web interface.
Was following the basic setup wizard and had put in the initial Hostname, password etc.
Switch management interface changed to 10.0.0.3 and could access it with that. Had not started to assign IP from the configuration pane when cable pulled out.
Now I can't access the switch again.

Can somebody help with what to do next in this case to follow through setup?
I'm not an expert, so please I'll like you to break down the approach and solution. Thanks in advance.

3 Replies 3

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

If you are able to access it anymore, you may want to try accessing via the console port. See the link below:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst1000/hardware/installation/8_16_port_hig/b_c1000_8_16_hig/configuring_the_switch.html

HTH

If you are not

Alright. Thanks for your response. I've ordered for a console cable.
I'll try with it and hopefully I get access and feel relieved.

Review Cisco Networking for a $25 gift card