09-28-2010 11:45 AM - edited 03-06-2019 01:13 PM
I have a Cisco 3750G running IOS 12.5 connected to HP Virtual Connect. The problem is that without a port-channel we can ping Virtual Connect fine from a Workstation. Both Virtual Connect and Workstation are in the same subnet. We built the Port-Channel with LACP (Access, Not Trunk Port) and now we can not ping at all. We made sure that the Virtual Connect configuration is set to Access, not Trunk as well. Below is my Cisco Config:
Can someone point out if there is an issue with the configuration.
Thanks
interface Port-channel1
no ip address
end
interface GigabitEthernet2/0/17
no ip address
speed 1000
no mdix auto
channel-group 1 mode active
channel-protocol lacp
interface GigabitEthernet2/0/18
no ip address
speed 1000
no mdix auto
channel-group 1 mode active
channel-protocol lacp
end
interface GigabitEthernet2/0/19
no ip address
speed 1000
no mdix auto
channel-group 1 mode active
channel-protocol lacp
interface GigabitEthernet2/0/20
no ip address
speed 1000
no mdix auto
channel-group 1 mode active
channel-protocol lacp
end
interface GigabitEthernet2/0/21
no ip address
speed 1000
no mdix auto
channel-group 1 mode active
channel-protocol lacp
end
09-28-2010 11:55 AM
is the port-channel up ??
09-28-2010 12:01 PM
Yes,
It is up!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide