cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1358
Views
0
Helpful
3
Replies

Can you replace the master in a 3750 stack without rebooting?

Michael Couture
Level 1
Level 1

I have two like switches in a stack (WS-C3750G-48PS 15.0(1)SE2 C3750-IPBASEK9-M). Switch#1 is the master and is the one that needs to be replaced. Can I force Switch #2 to be the master, then power down switch#1, remove switch#1, insert the replacement, and then power on the newly added switch without shutting down or rebooting switch#2?

Thanks.

1 Accepted Solution

Accepted Solutions

Gregory Snipes
Level 4
Level 4

You do not need to force switch 2 to become the master. It will automatically be promoted to the master as soon as you disconnect switch 1. You can then attach the new switch to the stack. You will need to ensure the new switch is running the same (or at least compatible) software. You may need to renumber the new switch once it is in place.

View solution in original post

3 Replies 3

Gregory Snipes
Level 4
Level 4

You do not need to force switch 2 to become the master. It will automatically be promoted to the master as soon as you disconnect switch 1. You can then attach the new switch to the stack. You will need to ensure the new switch is running the same (or at least compatible) software. You may need to renumber the new switch once it is in place.

Thanks, for the feed back.

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Just to add what Gregory has already described, switch two will remain master (until something causes another stack election).

By default, when there's a master change, gateway MACs change. This can confuse hosts that don't process the new master's gratuitous ARP.

There is a configuration option to retain the original master's MAC(s).

Review Cisco Networking for a $25 gift card