Can you use the same destination port for different RSPAN sessions?

[Havenra89]

We have multiple access switches that need to go to our sniffer which is on one port. Documentation says the destination port can participate in only one SPAN session at a time (a destination port in one SPAN session cannot be a destination port for a second SPAN session).

But doesn't mention RSPAN. 

Is this possible, example:

Monitor session 1

Source interface GiX/X

Destination remote vlan 200

Monitor session 2

Source interface FaX/X

destination remove vlan 201

Single destination port (where sniffer is)

Session 1

Source remote vlan 200

Destination interface fa1/3 < same port

Session 2

source remote vlan 201

Destination interface fa1/3 < same port

[paul driver · Accepted solution]

Hello

Yes you can, this would be the destination port that your network analyser would be attached, however you need to make sure this port can accommodate the traffic for all source span sessions

[balaji.bandi]

I do not see any issue, this is achievable.