Cannot add NIM-2T inside router in Packet Tracer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2023 08:10 AM
I am new to packet tracer so i wanted to connect a Serial DTE cable to a ISR4321 router but when i open the router in packet tracer and went to connect NIM-2T by dragging and droping onto the empty slot but it is not adding (My router power is off)
Os:- Kali Linux
TBH i was using it earlier it was working fine in Kali but my hard drive failed so i bought a new hard drive and reinstall the Kali after reinstalling Kali i installed packet-tracer and now this is the problem
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-11-2023 08:20 AM
Hi @v3g1t4
Unfortunatelly this is related to your installation, just test here with Windows and it is working fine. And you also mentioned that previously it was working.
Sounds odd but I think you need to reinstall PacketTracer and make sure you are running the software with proper privilege.
