We have an OSPF network with four 6500 Distribution Switches. They are fully meshed and see each other as peers and are sharing routes.
Off of one pair (Border) there is a setup of 3750G siwtches that go off to another network and they do not run OSPF.
Between the Border Dist and the 3750G Switches we run HSRP. The 3750G side uses HSRP GP 192 and the Dist Side uses HSRP 192.
There are static routes on the 3750G pointing to the Dist HSRP address to get back to network.
Pings fail from the OSPF side to the HSRP address on the 3750G side.
If I do a trace from the OSPF side to the HSRP address it hits one border dist switch then the other and fails.
If I have static routes on both border dist switches pointing to the HSRP on the 3750side, do we need to change the metric on one dist so that it is preferred over the other or should the router Id take care of that?